![background image](http://html.mh-extra.com/html/royal/er-145/er-145_manual_1493956015.webp)
RIBBON REPLACEMENT
IMPORTANT
The ER
comes equipped
the ribbon installed To prepare the register for operation simply remove the red adhesive tape that was
placed on the ribbon spools to secure them during transportation The ribbon spools are located
front of the printer
the journal
compartment The register printer and
ribbon spools are easily accessible by unlocking the journal cover
the
lock key
After unlocking
the cover forward and upward to remove
REPLACING THE INK RIBBON
The
ribbon releases special
to the paper which produces the printout After a period of
depending on the amount of use the
the ribbon
be used up When the printout becomes faint the ribbon needs to be replaced To remove the ribbon grasp each spool and
pull upward The ribbon spools
easily pull away from the
the ribbon from the front of the
away from the ribbon
guides
To install a new ribbon place one spool on a post and while holding the other spool guide the ribbon through the ribbon guides (shown
below) using a pencil to place the ribbon
track to make installation easier Place the other spool on the spool post and press both spools
down to secure The spool holder arm
automatically move away to allow the spool to slide down
position The spool holder arm
lock the ribbon spool
place when
properly seated Turn ribbon spools to take up any slack around the ribbon guides