A4
US
US
A4
US
A4
A4
US
47
Redefining Flow Control
STALL TIME
CPT 20
CMD SRCE
CPT 4
INFO
SPLT RANGE
RELAYS
ACT CFG
ADVANCED
POSIT
Position
SET PT
Setpoint
THRUST or TORQUE
Thrust or Torque
LOCREM
Local / Remote Control
MANJOG
Manual Jog
CL LIM
Close Limit (zero)
OP LIM
Open Limit (span)
CFG
Control Setup
CMD4
Field Command Signal4
CMD20
Field Command Signal20
DBAND
Deadband
FLTHST
Fault History Access
ADVANC
Advanced Menu
DEFLTS
Default Menu Access
STATUS
BASIC
INFO
ACT STS
AMP STS
TEMP
SWR VER
CTR SETUP
CTRLAL
IN DMP
LOS TO
LOS ACT
LOS LOW
LOS HI
TORQ O
TORQ C
CL ACT
OP ACT
RELAYS
RLY1 CFG
RLY1 POS
RLY1 FRM
RLY2 CFG
RLY2 POS
RLY2 FRM
ACT CFG
ACT TYPE
ACT SIZE
ENCOD IN
ASRACT
SP RANGE
MIN CMD
MAX CMD
BSRACT
ST CUST
LD CUST
DEFAULTS
LD FACT
fault history Menu
CMA fAuLT hIsToRy sTRIng defInITIons
fAuLT
sTRIng
desCRIpTIon
At Close Limit
CLL
The actuator was at or below the CLOSE LIMIT setting. .
At open Limit
opL
The actuator was at or above the OPEN LIMIT setting
esd Active
esd
The Emergency Shut Down feature was activated
dither
dIT
The unit is exceeded 2000, 1% position change per hour.
Critical fault
CRf
A Critical fault was been detected. The conditions that trigger this
status are TBD but are currently: Loss of Feedback, EERPOM Fault.
general fault
gnf
A General fault has been detected. The conditions that trigger this
status are TBD but are currently: Stall Open/Close, Over torque/
Thrust-Open/Close, Loss of comms, and Loss Command.
Relay one energized
R1
Relay one is energized.
Relay Two energized
R2
Relay two is energized.
eepRoM fault, params
ee
An error was found in the current parameter area of the EEPROM.
eepRoM fault, customer
Cee
An error occurred when the customer defaults were stored. The copy
is not reliable. The actuator was still allowed to run, but the customer
default settings should not be used. Currently this fault only occurs
upon the storage of the customer defaults. Cycling power will clear
the fault, but the data in the customer defaults would still be corrupt.
This denotes that it has happened. This is a record that it had
happened.
eepRoM fault, factory
fee
An error occurred when the factory defaults were stored. The copy is
not reliable. The actuator is still allowed to run, but the factory
default settings should not be used. Currently this fault only occurs
upon the storage of the factory defaults. Cycling power will clear the
fault, but the data in the factory defaults would still be corrupt. This is
a record that it had happened
Reset RsT
The actuator was reset (power cycled).
Monitor Relay
MnR
The actuator was not available for proper remote operation
(General or Critical Fault).
Local Control Knob stop
LCs
The local control knob was set to the LOCAL STOP position.
Local Control Knob
Remote
LCR
The local control knob was set to the REMOTE position.
Local Control Knob Local
LCL
The local control knob was set to the LOCAL STOP position.