BRP-Rotax
INSTALLATION MANUAL
Figure 8.8: Water inlet elbow
1
Water pump housing
2
Water inlet elbow
Use two M6x20 Allen screws lock washers to attach the water inlet elbow. Tighten screws
to 10 Nm (90 in lb.)
ATTENTION
The total slip-on length of the water inlet elbow and expansion tank should be used.
EXPANSION TANK
The aircraft manufacturer should give the possibility to the pilots to check the coolant level
in the expansion tank. It is also necessary to inform the pilots about the daily inspection of
the coolant level in the aircraft manufacturers Operators Manual.
To allow this inspection, e.g. a flap or panel on the cowling or a warning instrument in the
cockpit for low coolant level should be foreseen.
COOLANT HOSES
N
NO
OT
TE
E
For proper operation short hoses should be used.
Page 10
December 01 2017
Effectivity: 915 i A Series
Edition 0/Rev. 0
Summary of Contents for 915 iS 3 A
Page 165: ......