Rotax 24-30-00, Service Instruction

Page: 9 / 21

d
065
15.
fm
SI-PAC-001
SERVICE INSTRUCTION -
PAC
08 February 2019 24-30-00
Initial Issue Page 9 of 21
Copyright - BRP-Rotax GmbH & CO KG. All rights reserved.
3.3) Maintenance (Line) - related information
3.3.1) Checking the V-belt tension
General note In the case of configurations with additional external alternator, inspect attachment and V-belt ten-
sion.
Checking the
V-belt tension Inspect V-belt tension as per drawing below.
Fig. 4.
3.3.2) Adjust the V-belt tension
Belt tension To adjust the belt tension:
Fig. 5.
.
Step Procedure
1 Loosen the hex. screw M10 (1) and the 2 Allen screw M8 (2 and (3).
2 Press the alternator upwards and tighten Allen screw (3).
3 Then tighten Hex. screw M10 (1) with tightening torque 40 NM (30 ft.lb) and Allen
screw M8 (2) with tightening torque 22 Nm (195 in.lb).
m
WARNUNG
NOTICE
Deflection of the V-belt must not exceed 6 mm (1/4”) with al load of 50 N
(11 lb) at center.
1 Hex. screw M10
2 Allen screw M8
3 Allen screw M8
1
3
2
00353