Reader Functionality
AYC-Fx4 and AYC-Gx4 family manual
Page 26
5.2.5.
Return to Factory Default Settings
Warning:
You must be very careful before using this command! This will
erase the entire memory and return all codes to their factory
default setting.
1) Enter Programming Mode.
2) Press “0” to enter Menu 0.
•
The Transmit LED will Flash red.
•
The Program LED will flash
red.
3) Enter your 4 digit programming
code
•
If the Programming Code is valid, all memory will be erased,
you will hear three beeps and the controller will return to
Normal Mode
•
If the Programming Code is invalid you will hear a long
beep and the controller will return to Normal Mode without
erasing the memory of the controller
5.2.6.
Replacing a Lost Programming Code
In the event that the Programming Code is forgotten, the AYC-
Fx4/AYC-Gx4 may be reprogrammed in the field using the
following instructions:
1) Remove power from the reader.
2) Activate tamper by removing the reader from the wall or
removing the reader's case.
3) Apply power to the reader.
4) You now have 10 seconds to enter Programming Mode using
the factory default Programming Code 1234.
0
? ? ? ?
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Red
Red
