Ross NWE-TS, User Manual, Page: 3 / 68

Important Regulatory and Safety Notices to Service Personnel
Before using this product and any associated equipment, refer to the “ Important Safety
Instructions ” listed below to avoid personnel injury and to prevent product damage.
The NWE-TS makes use of a number of individual component products to make up a complete
turnkey system. The Important Safety Instructions section of this manual is intended to
compliment individual OEM product manuals and the user must refer to, and heed, any safety
instructions outlined in these supplementary product manuals. The following is a link to the
Dell® safety conformity instructions:
http://www.dell.com/content/topics/global.aspx/about_dell/values/regulatory_compliance
Product may require specific equipment, and/or installation procedures to be carried out to satisfy
certain regulatory compliance requirements. Notices have been included in this publication to call
attention to these specific requirements.
Symbol Meanings
Important Safety Instructions
Protective Earth
— This symbol identifies a Protective Earth (PE) terminal, which is
provided for connection of the supply system’s protective earth (green or green/yellow)
conductor.
This symbol on the equipment refers you to important operating and maintenance (servicing)
instructions within the Product Manual Documentation. Failure to heed this information may
present a major risk of damage to persons or equipment.
Warning
— The symbol with the word “ Warning ” within the equipment manual indicates a
potentially hazardous situation, which, if not avoided, could result in death or serious injury.
Caution
— The symbol with the word “ Caution ” within the equipment manual indicates a
potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. It
may also be used to alert against unsafe practices.
Notice
— The symbol with the word “ Notice ” within the equipment manual indicates a
potentially hazardous situation, which, if not avoided, may result in major or minor equipment
damage or a situation which could place the equipment in a non-compliant operating state.
Warning Hazardous Voltages
— This symbol is intended to alert the user to the
presence of uninsulated “dangers voltages” within the product enclosure that may be of
sufficient magnitude to constitute a risk of shock to persons.
ESD Susceptibility
— This symbol is used to alert the user that an electrical or electronic
device or assembly is susceptible to damage from an ESD event.
Warning
1. Read these instructions.
2. Keep these instructions.