Ross NWE-TS, User Manual, Page: 24 / 68

2–8 • Installation NWE-TS User Manual (Iss. 01)
Getting Started
This section provides additional information for installing the NWE-TS, and DashBoard before
you can proceed to cabling and configuring your NWE-TS. Refer to the
NWE-TS Quick Start
Guide that accompanied your device for installation information.
Installing the NWE-TS
Refer to the NWE-TS Quick Start Guide that accompanied your device for information on the
physical installation of the NWE-TS.
Connecting the NWE-TS Power Supplies
For redundancy, each power cord should be connected to a separate power source for protection
against failure of the A/C power circuit. In the event of one power supply failure, the frame load
is transferred to the other redundant power supply.
The power supply plugs into the right-hand section of the NWE-TS rear panel. The universal
power supply supports all worldwide AC power voltages, and no power adjustments are required
.
To connect the NWE-TS power supplies
1. Connect the cable’s female IEC connector to the right power socket. ( Figure 2.2 )
2. Plug the second IEC connector into left power socket.
3. Each AC connector includes a PowerLock, which is designed to retain the power cable
connector. Clip the PowerLock over the shoulder of the inserted AC Cable end.
4. Connect each supplied power cable’s three-prong male connector to an AC outlet.
5. Power on the NWE-TS by pressing the Power button on the front panel. Refer to Figure
2.2 for button location. The fans run at full speed for a short period at the startup.
Ethernet Connection
The exact steps for connecting to your facility via an ethernet network depend on the network
requirements for your facility. Contact your IT Department before connecting to your facility
network to ensure that there are no conflicts. They will provide you with an appropriate value for
the IP Address, Subnet Mask, and Gateway for the NWE-TS. Note that the NWE-TS is set for
DHCP by default.
For More Information on...
• physical connections on the NWE-TS rear panel, refer to the NWE-TS QuickStart Guide .
Warning
— In some countries, it may be necessary to supply the correct mains supply cord.
Use only an approved IEC 320 C-13 type A/C line cord rated for a minimum 10A at 250V and
certified for the country of use.
Warning Hazardous Voltages
— The safe operation of this product requires that a
protective earth connection be provided. This protective earth is provided by the grounding
conductor in the equipment’s supply cord. To reduce the risk of electrical shock to operator and
service personnel, this ground conductor must be connected to an earthed ground.