Ross ADC-8733AC, User Manual, Page: 52 / 60

5–2 • Specifications ADC-8733A User Manual (Iss. 02B)
ADC-8733A Technical Specifications
This section provides the technical specifications for the ADC-8733A.
Table 5.1 ADC-8733A Technical Specifications
Category Parameter Specification
Component Video
Input
Signal Standards Accepted YUV (SMPTE, BETA, and MII)
RGB (SMPTE, NTSC-Rel, MII)
Number of Inputs 1
Component Video 1V p-p nominal
Impedance 75ohm terminating
Return Loss >43.5dB to 6MHz
SDI Output
Signal Standards SMPTE 259M-C, 270Mbps 525/625-lines, 10 bits
Number of Outputs Full Rear Module: 4
Return Loss >20.0dB to 270MHz
Signal Level 800mV ±10%
DC Offset <50mV
Rise and Fall Time >800pS (20-80%, ±15%)
Overshoot <5% typical
Audio Input
(R1C-8733 and
R2C-8733 Rear
Modules)
Number of Inputs 4
Connector 3-Pin Plug to BNC
Impedance >10Kohm
Maximum Input Level +34dBu (input gain set to –10dBu)
Input Level Range ± 10dBu
Frequency Response ± 0.05dB 20Hz – 22kHz @ Fs = 48kHz
Audio Performance
(R1C-8733 and
R2C-8733 Rear
Modules)
Signal to Noise Ratio 100dB
101dB ‘A’ weighted
107dB CCITT weighting
Total Harmonic Distortion <100dB
Phase Linearity 1.2° @ 20kHz
Amplitude Linearity 0.6dB @ -100dBFS
Crosstalk >95dB
Minimum Audio Delay 3ms
Maximum Audio Delay 5sec
Analog Reference
Signal Standards Accepted NTSC, PAL-B, PAL-M, PAL-N
Number of Inputs 1
Input Impedance 75ohm
Return Loss >46dB to 6.75MHz