Ross ADC-8733AC, User Manual, Page: 17 / 60

ADC-8733A User Manual (Iss. 02B) Installation • 2–3
Installing the ADC-8733A
This section outlines how to install a Rear Module in a DFR-8300 series frame. The same
procedure applies regardless of the frame or card type. However, the specific Rear Module you
need to install depends on the frame you are using.
Rear Modules for the DFR-8310 Series Frames
When installing in the DFR-8310 series frames:
• ADC-8733A — The 8310AR-030 Rear Module (R1-8733) is required. The ADC-8733A
is also compatible with the DFR-8310-BNC frame.
• ADC-8733A-C or ADC-8733A-SC — The 8310AR-037 Rear Module (R1C-8733) is
required.
Rear Modules for the DFR-8321 Series Frames
When installing in the DFR-8321 series frames:
• ADC-8733A — The 8320AR-030 Full Rear Module (R2-8733) or the 8320AR-031 Split
Rear Module (R2S-8733) can be used. Ensure that the ADC-8733A is installed in an even
slot number.
• ADC-8733A-C or ADC-8733A-SC — The 8320AR-037 Rear Module (R2C-8733) is
required. The ADC-8733A-C and the ADC-8733A-SC are not compatible with the Split
Rear Module.
Installing a Rear Module
If you are installing the ADC-8733A in a DFR-8310-BNC frame, or the Rear Module is already
installed, proceed to the section “
Installing the ADC-8733A ” on page 2-4.
Use the following procedure to install a Rear Module in your DFR-8300 series frame:
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the ADC-8733A installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. Figure 2.1
Note
— An error message displays in the DashBoard HW Status field when using
the AAM-8581 daughter card with an unsupported Rear Module. The following Rear
Modules are not supported by the AAM-8581: 8310AR-030, 8310AR-031,
8320AR-030, 8320AR-031, 8320AR-040, and 8320AR-041.
Notice
— Do not install the ADC-8733A-C or the ADC-8733A-SC in slot 10 of the
DFR-8310 series frame when using a Network Controller Card. Doing so may
damage the Network Controller Card, the AAM-8581, or both.