Ross ADC-8733AC, User Manual, Page: 44 / 60

4–14 • Menus ADC-8733A User Manual (Iss. 02B)
Bank B Menu Parameters
This section briefly summarizes the menu parameters available in Bank B.
1- NTSC Setup
This menu controls what the card does to the incoming signal with respect to setup as follows:
• If the incoming signal has setup on it set this parameter to ON. The card will remove it
before it converts the component signal to SD-SDI.
• If the incoming signal does not have setup on it set this parameter to OFF
3- Vertical Interval Blanking
Use this menu to blank the vertical interval, or allow the signals in the vertical interval to pass
through the ADC-8733A.
4 - Vertical Interval End
The ADC-8733A has a programmable Vertical Interval that allows you to set where the VI ends
and the first line of active video begins. Everything up to (but not including) the first line of
active video is considered part of the Vertical Interval and will be affected by this function.
• In 525-line standard, signals in the vertical interval are passed without setup even if setup
is enabled. The Vertical Interval End can be set to line 19, 20, or 21.
• In 625-line standard, the Vertical Interval End is not adjustable and is set at 22.
5 SuperBlack
m
+
– Clip
Pass Through
SUPER BLK
CLIP
PASS
6 Vertical Bit Lock
m a
+
– Line 20
Line 10
V BIT LOCK
20
10
7
--
8
--
9
--
A Horizontal Crop
m
+
– On
Off
H CROP
ON
OFF
B Crop Left
m
+
– Increase
Decrease
CROP LEFT (##)
C Crop Right
m
+
– Increase
Decrease
CROP RIGHT (##)
D
--
E
--
F
--
a. When using a 525-line standard.
Table 4.10 Bank B Menu and Parameters Table
Menu
Select
Menu Parameters HUD Values