Ross ADC-8733AC, User Manual, Page: 45 / 60

ADC-8733A User Manual (Iss. 02B) Menus • 4–15
5 - SuperBlack
Use this menu to clip SuperBlack values from the input video signal as follows:
• Allow the input’s active video signal to pass through unaltered
• Clip any value below black
6 - Vertical Bit Lock
Some types of equipment require that the transition from vertical interval to active video to be
locked to either line 10 or line 20. Use this menu to select the V Bit location.
A - Horizontal Crop
The active video portion of an SDI video line is wider than that of an analog component video
line. The smaller active analog video is centered on that of the SDI video. Use this card to crop
the leading, the trailing, or both video samples on the output SDI video line. This will avoid
possible errors downstream if converting back to analog component video.
B - Crop Left
The output SDI video line can be cropped starting at the beginning of the line in increments of
one pixel up to 350.
C - Crop Right
The output SDI video line can be cropped from the end of the line backwards toward the
beginning of the line in increments of one pixel up to 350.
Bank C Menus
This section summarizes the functions available on Bank C.
Note
— V Bit location can only be moved in the 525-line standards.
Table 4.11 Bank C Menu and Parameters Table
Menu
Select
Menu Parameters HUD Values
0
Bank Select
+
+
–
A
B
C
D
BANK
A
B
C
D
1
Timing Mode
m
+
–
Frame Sync
a
Frame Delay
a
Line Sync
Line Delay
TIME MODE
FS
FD
LS
LD
2 Horizontal Delay
m
+
– Increase
Decrease
H DELAY (####)
3
Horizontal Reset
+
– Zero
No Action
H RESET ZERO