Ross ADC-8733AC, User Manual, Page: 40 / 60

4–10 • Menus ADC-8733A User Manual (Iss. 02B)
Heads-up Display Menus
This section summarizes the Bank Menu system of the Heads-Up Display and how to navigate
the menus and options using the
SW1 and SW2 switches on the ADC-8733A card-edge. A list of
the available menus and parameters is provided in the following tables. Note that the tables list
the functions in numerical order based on the value selected using
SW1 .
Overview
The menus are split into Banks: A, B, C and D. Each bank has 16 positions, 0 though F, with
position 0 (zero) reserved for the Bank designation. Positions 1 to F may contain menu items.
A particular menu is referred to as: Bank - Menu , for example A-9 . The ADC-8733A must be
unlocked to be able to adjust the parameters. To unlock the card, refer to the section. By default,
whenever the card is powered up, it is locked.
Parameters in the menus can be adjusted without turning on the Heads-Up Display, but using the
display gives visual feedback to ensure the parameter is adjusted correctly. The Heads-Up
Display is superimposed over all video outputs. To enable the Heads-Up Display, refer to the
section
Navigation
Use the following procedure to navigate the Bank Menus of the ADC-8733A:
1. Rotate SW1 to position 0 .
2. Toggle SW2 up or down to select the Bank.
3. Rotate SW1 to the required menu.
4. Toggle SW2 to select the required parameter.
This completes the procedure for navigating the Bank Menus of the ADC-8733A.
The tables in this section list all the menus and the possible parameters.To activate some of these
parameters, it may be necessary to toggle
SW2 in either direction, or it may require that SW2 be
held in either direction for a few seconds.
The following rules apply to the tables that are used throughout this section:
• The label “ + ” instructs you to toggle the Mode Switch ( SW2 ) up momentarily.
• The label “ – ” instructs you to toggle the Mode Switch ( SW2 ) down momentarily.
• The label “ + (h) ” instructs you to hold the Mode Switch ( SW2 ) up for one second.
• The label “ – (h) ” instructs you to hold the Mode Switch ( SW2 ) down for one second.
Ballistics
In those menus where there is a wide adjustment range, a mechanism to help speed up the
selection process is provided. If
SW2 is pressed and held in either direction, the values in the
menu will change at an increasing faster rate. The rate of change will reach its peak after
approximately two seconds. This is called
ballistics .
Note
— When the ADC-8733A is powered up or unlocked, it defaults to Bank A and
the Heads-Up Display is disabled.