ROSIERES Bocuse, Operating Instructions Manual

Page: 26 / 36

- 26
CHANGING THE GAS: the calorific capacity and pressure of the gas vary
according to the type of gas.
When changing the gas, you should successively:
* change the jets, see table page 28 for jet selection,
* correct the flame appearance by adjusting the air ring, see table page
28,
* and set the minimum flow of the gas burner tap.
¤ = Original setting: G20-10 mbar
X = Gas setting possible
GAS INSTALLATION
Example above: ultra-rapid
burner (x 2 jets)
TOP JET
0 2 G 1 3 G
s a G
r o t c e n n o c
r a b m 0 1 r a b m 5 , 7 2
d e r e p a t
1 - 7 O S I
Y L A R T S U A S U A
¤ X ¤
CHANGING JETS
Each jet is identified with a mark.
Burner jets
To access the jets of the top burners,
remove the top grills, caps and heads
of all the burners.
Use the key supplied with the cooker
to unscrew the jets.
According to the information given in
table page 28, install jets suitable for
the burner type and gas type supplied.
Screw them right down.
For reinstallation, fit the heads, burner
caps and grills.