23 -
Section 4
• The pyrolytic cleaning cycle can be delayed...
Setting a programming start time: pull out and turn the button clockwise to
put the ‘C’ pointer to the starting time, and release it.
Displaying a duration: turn the button clockwise, without pulling it, to display
the time required for the pyrolytic cleaning cycle.
The oven starts at the programmed time and stops operating automatically
once the time has elapsed. The end of the time is signalled by a bell that
rings for several minutes. To stop the alarm, turn the button to display .
Return the function selector knob to the stop position.
Pyroysis leaves a white residue on the oven walls. Wait for the oven to cool
completely then clean the inside of the oven with a damp sponge to wipe off
the residue.
RIGHT CATALYTIC OVEN
OVEN WITH CATALYTIC WALLS
– catalytic cleaning takes place while the oven
is in use. The oven walls are coated with a special enamel, micropores
encourage the combustion of grease. Each drop is eliminated by the combined
action of the catalytic enamel and heat.
• Regular cleaning:
the accumulation of fine residual dust resulting from the
combustion of grease may eventually reduce the enamel’s efficiency.
To keep this enamel in peak condition, you should rinse the walls with very hot
water after every 10-15 roasts. This quick job is made all the easier as the side
walls can be fully removed to be washed in the sink. They are fixed by a central
screw (unscrewed by hand) on the top of the wall, and held by two tabs at the
bottom; release them by lifting.
After rinsing and installing the sides in the cooker, dry the enamel by operating
the oven at maximum position for ¼ hour.
• If spills are large
, the enamel should be cleaned to let it recover its
efficiency. Follow these steps:
. Wipe any big spills or deposits with a sponge soaked in very hot water, using
ammonia liquid detergent.
. Use a nylon brush on any marks that cannot be wiped away.
. Then heat the oven for an hour set at the maximum thermostat position.
. It may be necessary to repeat these operations several times, if the spillages
are heavy.
Note:
if after normal use, you notice slightly darker marks on the oven walls
don’t worry, this effect is quite normal, they are just grease marks in the
process of being eliminated.
ENAMEL OVEN
– The oven has an enamelled surface when the catalytic side
walls are removed. Clean inside the oven with a sponge soaked in washing up
liquid and very hot water to remove hard grease marks. For heavy spattering use
commercially available oven cleaners.
Summary of Contents for Bocuse
Page 1: ...1 44000571 The Rosières Bocuse cooker Operating instructions B O C U S E RBC 127 AUS ...
Page 34: ... 34 ...
Page 35: ...35 ...
