VLT
®
8000 AQUA
Installation
[QUICK MENU] gives access to the
parameters used for the Quick menu.
It is possible to switch between the
Quick menu and the Extend menu
modes.
[EXTEND MENU] gives access to all
parameters. It is possible to switch
between the Extend menu and the
Quick menu modes.
[CHANGE DATA] is used for changing
a setting selected either in the Extend
menu or the Quick menu mode.
[CANCEL] is used if a change of
the selec-ted parameter is not to be
carried out.
[OK] is used for confirming a change
of the parameter selected.
[+/-] is used for selecting parameters
and for changing a chosen
parameter. These keys are also used
to change the local reference.
In addition, the keys are used in
Display mode to switch between
operation variable readouts.
[<>] is used when selecting a
parameter group and for moving
the cursor when changing numerical
values.
■
Indicator lamps
At the bottom of the control panel is a red
alarm lamp and a yellow warning lamp, as
well as a green voltage LED.
If certain threshold values are exceeded, the
alarm and/ or warning lamp is activated, and a
status or alarm text is displayed.
NOTE
The voltage indicator lamp is activated when
the AFD receives voltage.
■
Local control
Underneath the indicator lamps are keys
for local control.
[HAND START] is used if the AFD is to
be controlled via the control unit. The
AFD will start the motor, since a start
command is given by means of [HAND
START].
On the control terminals, the following
control signals will still be active when
[HAND START] is activated:
•
Hand start - Off stop - Auto start
•
Safety Interlock
•
Reset
•
Coasting stop inverse
•
Reversing
•
Setup select lsb - Setup select msb
•
Jog
•
Run permissive
•
Lock for data change
•
Stop command from serial
communication
NOTE
If parameter 201
Output frequency low limit
f
MIN
is set to an output frequency greater than
0 Hz, the motor will start and ramp up to this
frequency when [HAND START] is activated.
[OFF/STOP] is used for stopping the
connected motor. Can be selected as
Enable [1] or Disable [0] via parameter
013. If the stop function is activated,
line 2 will flash.
[AUTO START] is used if the AFD is to
be controlled via the control terminals
and/or serial communication. When
a start signal is active on the control
terminals and/or the bus, the AFD will
start.
MG.80.A7.22 - VLT is a registered Danfoss trademark
79
Rosewood STP ST42 General (Operation and Maintenance Manual - Part 4:
Section 6.3 Manufacturers Manuals 6.3.33 Danfoss VLT Aquadrive 8000) Vendor Manual
QP Id: VM207
Active: 03/09/2013
Page 85 of 208
