G A L A X Y ® A U R O U R A C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N G U I D E
123
Section 4 Troubleshooting Guide
4.18
Using IPMI to diagnose problems
Some NumaRAID arrays are equipped with an IPMI card (short for Intelligent
Peripheral Management Interface). This card or on-board chip is literally a
second computer, but is very small. It runs off the +5V standby which is used
to power the on/off switch, and is capable of communicating through the
motherboard even if the array is off. To access the IPMI services, make sure
you have a connection to the IPMI Ethernet port. Change the TCP/IP settings
on your client as follows:
IP address: 192.168.0.1
Subnet:
255.255.255.0
Gateway:
192.168.0.201
Open a network browser from the client, and type:
http://192.168.0.201
[enter]
You should see a login screen which looks like the following:
The login screen will prompt for a user name and password. The defaults are
ADMIN and ADMIN (must be capitalized).
