Installation
EVWM-V01-R1 Installation and Operation Manual
WallPod Intelligent EV Charging Unit
December 2022
Page
24
of
35
Connect the CT Cable to the Chargepoint
IMPORTANT:
A suitable cable gland must be installed to the chargepoint enclosure to
accept the CT cable and maintain the IP rating of the enclosure.
1. Locate the EV Charge Controller
enclosure and the connector
marked CT.
2. Connect one CT clamp wire to the
H+
terminal on the circuit board
connector.
3. Connect the other CT clamp wire to
the
H-
terminal on the circuit board
connector.
x
The CT wires do not have a
polarity.
Figure 15 Load Balancing CT Connection
NOTE:
The EV Charge Controller may be in a different orientation to that shown above.
S-
S-
S+
H-
H+
Summary of Contents for WALLPOD ROLEC4020B
Page 1: ...INSTALLATION OPERATION MANUAL Manufactured in the UK WALLPOD Intelligent EV charging unit...
Page 37: ......
Page 38: ......
Page 39: ......
