Installation
EVWM-V01-R1 Installation and Operation Manual
WallPod Intelligent EV Charging Unit
December 2022
Page
26
of
35
Configure Load Balancing
Configuration of the load balancing system is performed using the Smart Application as
part of the online configuration process.
The main fuse or circuit breaker in the property’s consumer unit should be labelled to state
the maximum load. The load balancing system
must
be set to the same figure (or lower)
than the main fuse or circuit breaker.
x
Do NOT set load balancing above the maximum point. Load balancing will not initiate
and all power to the property will be lost if the maximum point is reached.
Depending on the option selected by the installer…
x
Load balancing in a
domestic
system can be configured to initiate load balancing for
properties of between 60 Amps and 100 Amps.
x
Load balancing in a
commercial
system can be configured to initiate load balancing
for properties of between 60 Amps and 255 Amps.
Install Charge Plug Holsters
Charge Plug Holsters are used with tethered cable charges to help maintain the charging
cable and plug in a serviceable condition, free from damage and contamination. Use of
the holster also reduces the opportunity for the cable to be a trip hazard.
1. Establish a suitable installation
location close to the chargepoint.
x
If possible, choose a location
that is sheltered from the worst
of the weather as this will help
to maintain the working life of
the equipment.
2. Position the holster in the desired
location.
x
Make sure the holster is level
and vertical.
3. Use the holes in the holster as guide
to mark where the holster will be
secured to the wall.
4. Drill appropriate holes in the wall for
the fixings that will be used.
5. Secure the holster to the wall using
appropriate fixings for the location.
Figure 17 Mount the Plug Holster
NOTE:
Mounting point holes are approximately 6 mm diameter.
6. When the socket holster(s) is installed, loosely coil the tethered cable and hang it
on the holster. Connect the charging plug to the holster.
90°
Summary of Contents for WALLPOD ROLEC4020B
Page 1: ...INSTALLATION OPERATION MANUAL Manufactured in the UK WALLPOD Intelligent EV charging unit...
Page 37: ......
Page 38: ......
Page 39: ......
