An Error Message Appears
6
FA
Q
127
[SHEET SET ERROR SET AGAIN]
The loading lever was lowered while no media was loaded.
Raise the loading lever, place media at the correct location, then lower the lever again.
P. 33, “Loading Media”
[SHEET TYPE] is set to "OPAQUE," but transparent media was loaded.
Raise the loading lever, set the [SHEET TYPE] menu item to "CLEAR," then reload the media.
P. 98, "Speeding Up Output for Narrow Media"
The loaded media is too small.
Press any key to clear the error. Replace with media of usable size.
[TEMPERATURE IS TOO LOW **°C]
The temperature of the location where the machine is installed has fallen below the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch off the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (15 to 32°C) and allow the machine to come to room temperature, then turn on the power.
[DATA ERROR CANCELING...]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check for a problem with the connector cable or the computer, and redo the
operation from the step of loading the media.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the specified type.
[AVOIDING DRY-UP TURN POWER OFF]
The print head was forced to standby position to prevent them from drying out.
Operation cannot be continued. Switch the sub power off, then back on.
[SET HEAD HEIGHT TO xxx]
The height of the print head is lower than the height specified on the computer.
This warning indicates that the height of the print head is too low for the media thickness specified on the
computer. The heads move to a location where you can operate the height-adjustment lever. Adjust to the
displayed height, then press
.
P. 94, "Adjusting Head Height to Match Media Thickness"
