2
Basic
Operation
Setup of Media
47
6.
Setting the Drying Method and Time after Printing
* Go to the procedure
7.
when the water-based pigment ink (FPG) model is in use.
Press
to select the item.
Press
to enable the setting.
For the individual setting method of this setting item and the description, refer to
p. 89, "Drying the Trailing
Edge of the Printing Area on the Dryer."
Press
to select the item.
Press
to enable the setting.
For the individual setting method of this setting item and the description, refer to
p. 90, "Setting the Drying
Time after Printing."
7.
Saving the Setting as Preset
Press
to select [SAVE].
Press
to enable the setting.
If you select [NEXT], the performed settings are retained. But your
settings are overwritten or deleted, when you operate the [Media
Setting] menu again or switch off the main power of this machine.
FEED FOR DRY
DISABLE
ENABLE
Drying Method after Printing
After the 1st page is printed, set that the media should be fed until the trailing edge of the printed
area is positioned directly on the dryer. To make sure to dry the entire printed area, [ENABLE] If [DIS-
ABLE] is selected, the trailing edge of the printing area is not fed to the dryer unless you continue
with a subsequent printing.
DRYING TIME
10min 10min
Example of setting time (general guide):
* The setting time varies according to the settings of type of media
and printing quality.
<Condition> non-coated vinyl media
<Setting time> about three minutes
Drying Time after Printing
Set the drying time after the 1st page is printed. The next operation is not started until the set time
passes.
PRESET
[SAVE] NEXT
Current setting
Setting after
changed
Current setting
Setting after
changed