Roland MC-808, Owner'S Manual, Page: 59 / 156

59
Playing patterns
Pattern mode
1.
Hold down [SHIFT] and press one of the D BEAM [SOLO SYNTH]/[TURNTABLE]/[FILTER] buttons.
The Setup screen will appear.
fig.03-058
2.
Use [CURSOR ] to select a parameter, and turn the VALUE dial or use [INC] [DEC] to set the value.
3.
Press [WRITE] if you want to save your settings.
Press [EXIT] to close the Setup screen.
D Beam settings are saved as part of the System settings.
Editing the D Beam controller settings
Parameter Range Description
SOLO SYNTH
Pat Bank
(Solo Synth Patch Bank) See “Patch list” (p. 3) in
“Sound & Parameter List” .
Specifies the patch played by the solo synth.
Pat
(Solo Synth Patch Number)
Note
(Solo Synth Note)
0(C-)–127(G9) Specifies the basic pitch of the solo synth.
Scale
(Solo Synth Scale) FREE,
CHROMATIC Switches the scale on/off.
FREE: Smooth pitch change
CHROMATIC: Pitch change in semitone steps
Range
(Solo Synth Range) 2OCTAVE,
4OCTAVE Specifies the pitch range of the solo synth.
Level
(Solo Synth Level) 0–127 Specifies the volume of the solo synth.
TURNTABLE
Type
(Turntable Type) DOWN,
UP Specifies the type of turntable.
DOWN: The effect will increase as you move your hand clos-
er.
UP: The effect will increase as you move your hand away.
Control
(Turntable Control) BPM,
PITCH,
BOTH Specifies the parameter controlled by the D Beam.
BPM: Control the tempo (BPM).
PITCH: Control the pitch.
BOTH: Control both tempo and pitch.
FILTER
Type CONTROL CHANGE,
BEND UP, BEND DOWN,
BEND UP/DOWN,
CH AFTERTOUCH,
START/STOP,
GLISSANDO,
ADLIB, ARP OCT UP,
ARP OCT DOWN,
ARP OCT BOTH,
ARP DURATION,
BPM UP, BPM DOWN,
PITCH UP, PITCH DOWN,
ALL MUTE Specifies the parameter controlled by the D Beam.
CONTROL CHANGE: Modifies the control change specified
by CC#
BEND UP, BEND DOWN, BEND UP/DOWN: Pitch bend up/
down
CH AFTERTOUCH: Channel aftertouch
START/STOP: Start/stop the pattern or song
GLISSANDO, ADLIB: Vary the pitch
ARP OCT UP, ARP OCT DOWN, ARP OCT BOTH: Arpeg-
gio octave up/down (maximum three octaves)
ARP DURATION: Duration of each note in the arpeggio
BPM UP, BPM DOWN: Tempo up/down
PITCH UP, PITCH DOWN: Pitch up/down
ALL MUTE: Mute all parts
CC # CC01–CC31,
CC33–CC95 Specifies the control change number.
* You can set this only if Type is set to “Control Change.”
Range Lower 0–127
Specify the lower limit of the range of the D Beam controller.
Range Upper 0–127
Specify the upper limit of the range of the D Beam controller.
MC-808_r_e.book 59 ページ ２００７年７月１７日 火曜日 午後５時１分