Roland MC-808, Owner'S Manual, Page: 24 / 156

24
Basic operation of the MC-808
If you find the display difficult to read, use the following procedure
to adjust the display contrast.
fig.02-020
1.
Press [SYSTEM] to enter System mode.
2.
Hold down [SHIFT] and press keyboard pad [1].
3.
Use [CURSOR ] to select “LCD Contrast.”
fig.02-010
4.
Either turn the VALUE dial or use [INC] [DEC] to set the
value.
Higher values will make the characters darker.
Range: 1–8
5.
To save the setting you made, press [WRITE].
If you decide not to save the setting, press [EXIT] to return to
the previous screen.
Use the VALUE dial to make large changes in a value, or use the
[INC] [DEC] to change a value in steps of one.
An underline character is shown under the location where you can
modify a value. This is called the “
cursor .”
fig.02-011.e
If a screen contains more than one value that can be edited, use the
[CURSOR ] buttons to move the cursor to the value you want
to edit.
• Holding down [SHIFT] as you move the VALUE dial increases
value increments so you can make large value changes faster.
Key repeat function
• The value will continue changing if you press and hold [INC]
[DEC].
• The cursor will continue moving if you press and hold a
[CURSOR ].
Turbo repeat function
• The value will increase rapidly if you hold down [INC], then
press and hold [DEC].
• The value will decrease rapidly if you hold down [DEC], then
press and hold [INC].
• The cursor will move rapidly if you hold down a [CURSOR
] button and then press the opposite [CURSOR] button.
Adjusting the display contrast
(LCD Contrast)
3
1
5
2
4
Modifying a value
Quickly changing a value
Cursor
MC-808_r_e.book 24 ページ ２００７年７月１７日 火曜日 午後５時１分