Roland Camm-1Pro GX-300, User Manual

Page: 81 / 102

What to Do If …..
4
Ma
inte
na
nce
/ F
AQ
79
Cut Lines Are Uneven or Not Cut Attractively.
Are the blade and blade holder installed correctly and securely ?
Install them tightly enough not to loose.

P. 35, “Installing the Blade”
Are there material debris in the blade holder?
Remove the cap from the blade holder and clean out the debris.

P. 74, “Cleaning”
Is a thick material being used?
When you are using thick material, set the [QUALITY] to [HEAVY].

P. 46, “Detailed Cutting-condition Settings”
When you are using thick material, set the [QUALITY] to [HEAVY].
Replace with a new blade holder.

P. 75, “Consumable Items”
Is the blade protector damaged?
Replace with a new blade protector..

P. 75, “Consumable Items”
Replace with a new blade protector.
Set at an appropriate value.

P. 46, “Detailed Cutting-condition Settings”
Also, depending on the program you're using, you may be able to set the offset with the program. In such
cases, make sure that the program setting does not conflict with the machine's setting.
Uncut Areas Remain or the Material Is Not Cut
Is the blade chipped ?
If it is, replace it with a new one.

P. 35, “Installing the Blade”
Are blade force, blade offset, and cutting speed appropriate for the material being
cut?
Carry out a cutting test and set the appropriate values.

P. 46, “Detailed Cutting-condition Settings,” p. 38 “Adjusting the Blade Force,” p. 39 “Adjusting the Cutting Speed”