Roland Camm-1Pro GX-300, User Manual

Page: 82 / 102

What to Do If …..
4
Ma
inte
na
nce
/ F
AQ
80
The Carrier Paper Is Cut
Are the amount of blade extension and blade force appropriate for the material being
cut?
Adjust the amount of blade extension and the blade force appropriately.

P. 46, “Detailed Cutting-condition Settings,” p. 38 “Adjusting the Blade Force,” p. 39 “Adjusting the Cutting Speed”
The Material Rise Up During Cutting, and the Blade Scratches the Material
Is wide material being used?
When using material having a width grater than 762 mm (30 in.), lower the middle pinch roller at a position
over a grit roller near the center of the material.
Is the up speed too fast?
Use the menu to lower the setting for [UPSPEED].

P. 46, “Detailed Cutting-condition Settings”
The Start and End Points for Cutting Are Not Same
Are the blade and blade holder installed correctly and securely ?
Install them correctly and securely enough not to loose.

P. 35, “Installing the Blade”
Are you using thick or hard material?
When you are cutting thick or hard material, the start point and end point might not be same.
Blank Areas Are Produced On the Material
Are the blank areas due to the specifications?
Mechanical limitations produce margins at the front, back, left, and right of the material

P. 49, “Details of the Origin-point Location and Cutting Area”