Roland Camm-1Pro GX-300, User Manual

Page: 42 / 102

40
2
Basic Operation
Starting / Quitting Cutting
Setting the Origin Point
With this machine, you can set the location where cutting starts (the origin point) at any position. If the default
origin point just after setup (pressing
) is acceptable, there is no need for you to explicitly set the
origin point. Setting the origin point at the point you want on the material lets you start cutting at any location
you like, which can help reduce wasted material.
Procedure

Press to move the blade to the location where you
want to set the origin point.

Hold down for 0.5 seconds or longer.
The origin point has been set.
Material Test Feed
Perform test feed beforehand to ensure that the roll material is not pulled with undue force during cutting.
If the roll material is pulled with undue force during cutting, a motor error may occur, or the position may be
displaced. Test feed can also be performed to make sure that the loaded material is straight. Using the [AREA]
feature makes it simple to perform test feed for the required portion. Make sure that the type of the material
has been selected using the operation panel and that material loading has been completed.
Procedure

Make sure the brake is released.

Press several times until the screen shown in the
figure appears.
Press .

Press .

Press several times until the screen shown in the
figure appears.
Press .

Press to make the setting for the required
material length.
Set the length that is about 0.2 m longer than the required material length.
(A positive value signifies material feed toward the front, and a negative
value signifies material feed toward the back. If you are performing front
loading, set the length to a negative value.

P. 57, “Front Loading”

Press to start the test feed.

Press go back to the screen shown in the figure.