Roland Camm-1Pro GX-300, User Manual

Page: 99 / 102

Specifications
5
Main Specifications
97
*1
According to material and cutting conditions as specified by Roland DG Corp. (refer to the figure below).
*2
Excluding stretching/contraction of the material
*3
Range for assured repetition accuracy

For materials with a width exceeding 610 mm (24 in.): Length 4,000 mm (157-7/16 in.)

For materials with a width of 610 mm (24 in.) or less : Length 8,000 mm (314-15/16 in.)
(*1) The following conditions must be satisfied:

Material type: 3M Scotchcal Mastercut Film

Special stand (a roll material must be set at the rear and on the sheet hanger)

Side margins: 25 mm (1 in.) or more for both the left and right margins

Front margin: 30 mm (1-3/16 in.) or more
(After loading the material, using the display menu to select [F-EDGE] as the material type automatically sets a front
margin of 30 mm (1-3/16 in. ). )

Use of the display menu’s [AREA] function to perform feed of the material length plus 0.2 m and set the material cor-
rectly

Cutting the following data one time
Movable pinch roller
(right)
Side margins: 25 mm (1 in.) or more
Blade
protector
Side margins:
25 mm (1 in.)
or more
Movable pinch
roller (right)
(1) The letters are cut in order starting with “R”
(2) After the last letter (“P”) has been cut, the machine
returns to the origin point and the outer border is cut
Origin
X
Y
Cut width
Fills the
hard clip
Feed length
Material with a width exceeding 610 mm
(24 in.): 4,000 mm (157-7/16 in.)
Material with a width of 610 mm (24 in.) or
less: 8,000 mm (314-15/16 in.)
The origin is rotated 90 degrees ([ROTATE] on the display
menu is set to [90deg]).
Front margin: 30 mm
(1-3/16 in.) or more