Roland Aproll MDX-540, User Manual

Page: 51 / 120

3-4 Moving the Tool

WARNING: This procedure makes the machine operate. Before you perform this
procedure, check to make sure that operation of the machine will not create any
hazard or danger.
Click a feed button.
Operation Using the Handy Panel
You can also perform this operation using the handy panel.

P. 77 "Chapter 5 Handy Panel"
Selecting one of these enables "step feed." Each click
of a feed button moves the specified number of
steps. One step is 0.001 millimeters. Note that when
you're in the RML-1 mode, [x1] cannot be selected.
Selecting one of these enables "jog feed." Holding
down a feed button performs continuous move-
ment at the selected speed.
When you're finished with the operation, use this
button to close the window.
Feed buttons
These move the tool.
Clicking this button performs rapid movement to
the back-left area of the table (the VIEW position).
This is useful when you want to examine the state
of the workpiece (the material to cut).
49
Chapter 3 Basic Operation