4-5 Using the Tool Sensor
What's a Tool Sensor?
The tool sensor is useful for such tasks as setting the Z-axis origin.
Important !
When using the machine, check that no cutting waste and the like is present on the tool sensor, the terminal part of the sensor
cable, and tool. Otherwise, correct measurement may be impossible and the intended cutting results cannot be obtained.
Setting the Thickness of the Tool Sensor
Before you use the tool sensor, make the setting for its thickness. This setting directly affects the accuracy of the tool sensor,
so be sure to set the value accurately.
Procedure
In VPanel, click the [Setup] icon.
Click the [Modeling Machine] tab.
For [Thickness of Tool Sensor],
enter the thickness.
Click [OK].
Chapter 4 Getting Ready for and Performing Cutting
73
Summary of Contents for Aproll MDX-540
