ROJ SUPER ELF X3, Operating Instructions Manual

Page: 12 / 24

SUPER ELF X3
– Dornier
11
Off - Automatic position control deactivated
0 - Automatic position control activated with lower reserve storage
1 - Automatic position control activated with standard reserve storage
2 - Automatic position control activated with maximum reserve storage (the take-off point is
nearby the stopper pin)
• Recommended setting: 1
Reserve windings (to be set when Automatic = OFF)
It sets the number of coils to be wound on Spool body when a new Reserve is loaded. Set the
highest number of coils possible, avoiding them to overlap each other nearby the stopper pin
(the reserve has to be over 3/4 of the spool body length).
• Possible setting: 12 -> 68.
• Recommended setting: according to the yarn count, set the coils pitch as low as possible.
Note: In case of different reserve position between Feeders, set with the same number of
coils and make them equal by adjusting the coils pitch.
Filling Tensioner (Pulsar HP)
Stroke
This parameter allows set the stroke angle value:
• Possible setting:
off brake disabled
1 minimum stroke angle
2 low stroke angle
3 middle stroke angle
4 high stroke angle
5 maximum stroke angle
Set here the Yarn type
Possible settings:

fiber

filament < 500dTex

wool

filament > 500dTex
The Pulsar HP will automatically use the factory
pre-settings according to the chosen yarn type