Rohde Ecotop 20, Instruction Manual

Page: 27 / 80

Level: 10 / 2020 Page
11
of 16
en
gli
sh
7.1.4. Dismounting kiln stand
If necessary you can also remove the kiln stand from the
floor�
To do this, loosen the supporting screws on the front
(figure 15) and back (figure 16)� Now you can lift the floor
and place it horizontally on an even surface� Do not stand
it vertically on its side!
7.2. Swivel kiln stand
We have designed a swivelling kiln stand (figure 17) that
will allow you to adjust the height to your own require-
ments�
First detach the castors (only for models up to TE 75
MCC+) (figure 18)�
Now loosen the black plastic feet and remove them from
the kiln stand (figure 19)�
Finally remove the plastic cap (figure 20) from the upper
part of the kiln stand�
Now you can turn the kiln stand into the correct height�
Change the respective components to the opposing fixing
devices�
7.3. Example for positioning furniture plates
Place the enclosed 3 small cordierite blocks (figure 21) on the floor of the kiln, then place one of the furniture plates
(optional equipment/accessory) on top (figure 22)� Please note that all plates and stilts must be burnt-in (see section
5�9)!� Do not place the plates too close to the heating elements as this might cause the plates to crack� The distance
to the heating element should be at least 20 mm�
We suggest that the furni-
ture plates are supported in
3 points (figure 23) – for 2-
piece furniture plates 3 stilts
per plate – and that the stilts
are positioned one on top of
the other for each layer�
Otherwise the plates might
be exposed to stress from
bending and suffer from de-
formation or cracking�
figure 20
figure 17 figure 18
figure 19
figure 21 figure 22 figure 23
figure 15 figure 16