Unpacking the R&S AM300
R&S AM300
E-1007.9922.12
3-38
Operating manual, 02/2005
3
Putting the R&S AM300 into Operation
This chapter
Chapter 3 describes how to put the R&S AM300 into operation.
Further
information
Chapter 2 contains an overview of the R&S AM300‘s control elements,
indicators, etc.
Chapter 4, “Getting started”, takes you step-by-step through a number of
simple measurements.
Chapter 8 is an in-depth description of the instrument’s interfaces.
Caution
Before putting the R&S AM300 into operation, make the following checks:
Ensure that the ventilation holes are free of obstructions.
Ensure that there are no unsuitable signal voltages connected to the
input.
The R&S AM300’s outputs may not be overloaded and correct polarity
must be ensured.
The instrument may be damaged if the above checks are not performed.
3.1
Unpacking the R&S AM300
Recommended
procedure
When you unpack the R&S AM300, proceed as follows:
1.
Remove the R&S AM300 from its packaging and check that the delivery
is complete using the accessory list ( 1-35).
2.
Carefully check the R&S AM300 for any damage.
3.
If there is damage, immediately contact the carrier who delivered the
instrument. Under these circumstances, it is essential to keep the box in
which the R&S AM300 was transported and the packaging material ( 0-
17).
3.2
Setting up the Instrument
Caution
There is a risk of injury from sharp edges and becoming wedged between the
setting lever and the handle.
Setup instructions
The R&S AM300 must be assembled on a firm, level surface only. The
instrument has a carrying handle which is also used for various setup options.
This handle can be moved into any position, depending on the particular field
of application.
Summary of Contents for AM 300
Page 2: ...02 2005 ...
