Preparing for use
R&S
®
AMN6500
14
User Manual 1352.1213.02 ─ 01
4
Preparing for use
Before the R&S
AMN6500 is set up for operation, read the
4.1
Setting up the R&S
AMN6500
Putting the R&S
AMN6500 into operation
Execute the following steps in the order as described. Additional important information
is provided in separate chapters that are linked within each step.
1. Place the R&S
AMN6500 on a non-flammable surface (e.g. metal plate, marble
slab).
2. Remove all surrounding items that could obstruct the ventilation openings of the
R&S
AMN6500.
3. Establish an auxiliary
of the R&S
AMN6500 that is
independent from the mains supply.
4. Check if the voltage of the mains supply corresponds to the
AMN6500. Otherwise an external power supply can be neces-
sary.
5.
DANGER!
Risk of electric shock. Before you connect the V-network to the power
source, you have to connect the R&S
AMN6500 to a protective ground terminal. An
unearthed R&S
AMN6500 is live. Touching a live electrical device causes serious
personal injury, or even death.
The protective ground connection must remain until you have disconnected the V-
network from the power supply.
Connect the R&S
6. Connect the
AMN6500.
7. Connect the
to the R&S
AMN6500.
Establish a reference ground connection for RF noise voltage measurement.
8.
.
Taking the R&S
AMN6500 out of operation
Execute the following steps in the order as described:
1.
DANGER!
Risk of electric shock. Always disconnect the R&S
AMN6500 from the
power source before disconnecting it from anything else, especially the protective
ground. An unearthed R&S
AMN6500 is live. Touching a live electrical device cau-
ses serious personal injury, or even death.
The protective ground connection must remain until you have disconnected the V-
network from the power supply.
Setting up the R&S
AMN6500
