Instrument Tour
R&S
®
RTE
25
Getting Started 1326.1026.02 ─ 08
Mixed signal option R&S RTE-B1 / digital extension port R&S RTE-B1E
The mixed signal option R&S
RTE-B1 provides logic analizer functionality and 16
digital channels. It also can connect the R&S
RT-ZVC multi-channel power probe.
The connectors can be used to connect two logical probes with 8 digital channels
each (D0 to D7 and D8 to D15), or two flat interface cables of R&S
RT-ZVC.
The digital extension port R&S
RTE-B1E provides the connectors for the
R&S
RT-ZVC multi-channel power probe without MSO. The connectors can be
used to connect two flat interface cables of R&S
RT-ZVC.
One of the options can be installed in the option slot at the rear panel.
The maximum input voltage is 40 V peak at 100 k
Ω
input impedance. The maxi-
mum input frequency for a signal with the minimum input voltage swing of 500 mV
(V
pp
) is 400 MHz. For detailed specifications, refer to the data sheet.
Waveform generator option R&S RTE-B6
The waveform generator can generate various function and arbitrary waveforms,
sweeps, and parallel patterns. For detailed specifications, refer to the data sheet.
The option can be installed in the option slot at the rear panel.
The module provides the following connectors:
[Gen1, Gen2]
BNC connectors
[PattGen]
Connector for the pattern generator
GBIP option R&S RTE-B10
The GBIP option provides a GBIP interface and connector for remote control. For
detailed specifications, refer to the data sheet.
4.3
Keys and Controls
4.3.1
POWER Key
The [POWER] key is located on the lower left corner of the front panel. It starts up
and shuts down the instrument's software.
The light of the key shows the instrument state:
●
Orange: standby, the main power switch is on, the software is shut down.
Keys and Controls
www.allice.de
Allice Messtechnik GmbH
