Rockwell Automation DEVICENET 1771-SDN, User Manual

Page: 43 / 139

Publication 1771-6.5.132 - June 2000
Hardware Setup 3-5
Installing the 1785-ENET
Ethernet Module
To go online to the PLC-5 processor via Ethernet, you must install a
1785-ENET module in the 1771 I/O chassis.
The Ethernet module is shipped with a 58-pin connector header that
attaches to the PLC-5 processor.
1. Attach the connector header to the PLC-5 processor.
2. Use the captive screws to connect the interface module to the
processor.
Status Indicator
Transmit Indicator
External Transceiver
Fuse
Channel 3A:
15-pin AUI
Connector Port
IMPORTANT
Make sure you carefully align the pins and holes
before you press the connector header into the
processor. If you improperly align them, you will
bend the connector header pins when you press
them together. Do not use excessive force on the
connector header when seating it into the processor.
You do not need to key the connector.
Push the exposed pins
into the holes on the
PLC-5 processor.
Attach the interface
module to this end.
Connector
Header