Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 23 / 104

Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019 23
Chapter
3
Operate the Terminal
Install a Connection Cable
to a MobileView Terminal This section provides details on the following topics:
• Remove the Back Cover
• Install the Connection Cable to the MobileView 2711T Terminal
• Relocate the Connection Cable
Remove the Back Cover
This section shows how to remove the back cover of the MobileView 2711T
terminal. When the back cover is removed, you have access to the area that
contains all connectors except the USB port.
1.
Place the MobileView 2711T terminal with the display side down on a
stable, flat surface free of debris.
Topic Page
Install a Connection Cable to a MobileView Terminal 23
The 22-pin MobileView Connection Cable 29
Adjust the Touch Screen 30
Shut Down the MobileView 2711T Terminal 31
Install the Mounting Brackets 32
IMPORTANT 20-pin connection cables work only with first generation MobileView™ 2711T
terminals and IP20 junction boxes. Its cable connector (shown as S1 on
page 28 ) is silver.
22-pin connection cables are meant for second generation MobileView 2711T
terminals and IP65 junction boxes. Its cable connector (shown as S1 on
page 29 ) is black.
The following installation instructions apply to either connection cable type.
SHOCK HAZARD: Disconnect all power to the MobileView 2711T terminal
before you remove its back cover.
When the back cover is removed, the MobileView 2711T terminal is sensitive to
electrostatic discharge (ESD).