Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 31 / 104

Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019 31
Operate the Terminal Chapter 3
Shut Down the MobileView
2711T Terminal To shut down the MobileView 2711T terminal, perform the following steps.
1.
Close any open applications and return to the MobileView 2711T
terminal desktop.
2.
Tap on the desktop task bar to shut down the MobileView 2711T
terminal.
3.
Tap OK on the shutdown confirmation dialog box.
The terminal shuts down.
Disconnect Power from the MobileView 2711T Terminal
To disconnect power from the terminal, disconnect the tethered cable from the
MobileView junction box.
IMPORTANT If you disabled EWF to make application changes, then you must enable EWF
again before your shut down the MobileView 2711T terminal.
Review Enhanced Write Filter (EWF) on page 57 before you shut down the
MobileView 2711T terminal.
IMPORTANT Do not disconnect the tethered cable from the junction box until you first shut
down the MobileView 2711T terminal.
If you disconnect power from the terminal before you first shut it down, then
you risk the following:
• You can corrupt the Windows operating system
• You lose application settings that were changed while the terminal was
powered up
• You can corrupt any applications that were running, such as FTView ME