Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 27 / 104

Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019 27
Operate the Terminal Chapter 3
Relocate the Connection Cable
Use the following tools to relocate the connection cable.
• 19 mm open-end wrench or spanner
• Torx T10 screwdriver
• 8 mm hex key
To relocate the cable, perform the following steps.
1.
Remove the plug with the 8 mm hex key from the side where you are going
to relocate the cable.
Set the plug aside.
2.
Unscrew the strain relief from the connector-cable mounting assembly
with the 19 mm open-end wrench or spanner.
3.
Disconnect the connector-cable mounting assembly from the cable
connection of the terminal with the 19 mm open-end wrench or spanner.
4.
Remove the back cover as detailed on page 23 .
5.
Disconnect the terminal connections at S2, S3, and S4. See Figure 1 on
page 24 for their locations.
6.
Gently pull the cable while you guide the three disconnected terminals out
through the cable channel and cable connection.
7.
Follow step 6 through step 11 on page 26 to complete the cable relocation.
8.
Reinstall the plug with the 8 mm hex key in the cable connection from
which the cable was removed.
Torque the plug to 1.2 N•m (10.6 lb•in.).
TIP See step 5 on page 26 to identify the components in steps 2 and 3.
IMPORTANT Do not force the disconnected terminals through the channel, or wires
can be stripped from their connectors.