Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 26 / 104

26 Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019
Chapter 3 Operate the Terminal
4.
If present, unscrew and remove the gray fitting from the connector-cable
mounting assembly.
5.
Unscrew the strain relief from the connector-cable mounting assembly to
allow the red cable to slide freely.
6.
Gently feed the three terminals at the end of the red cable into the chosen
cable connection and up through the cable channel.
7.
When the three terminals reach the main circuit board, carefully plug each
terminal into its connection. See
Figure 1 on page 24 for where each terminal
is connected.
8.
After each terminal is securely connected, reinstall the back cover.
Use a Torx T10 screwdriver to reinstall the three cover screws.
9.
Install the connector-cable mounting assembly into the cable connection
of the MobileView 2711T terminal.
10.
Reinstall the strain relief to the connector-cable mounting assembly.
11.
Tighten the strain relief and the connector-cable mounting assembly with
the 19 mm open-end wrench or spanner.
Torque the connector-cable mounting assembly to 1.2 N•m (10.6 lb•in.).
12.
If you chose left-hand operation, reinstall the plug in the open cable-
connection port with an 8 mm hex key.
Torque the plug to 1.2 N•m (10.6 lb•in.).
IMPORTANT Do not force the cable terminals through the channel. If you encounter
resistance, slowly pull the cable towards you until it moves freely again.
If necessary, slide the connector-cable assembly farther down the
cable to assist cable feed through the channel.
IMPORTANT Verify that there is a snap sound when you plug each terminal into its
corresponding connection, which confirms that the terminal is
properly connected.
Strain Relief
Connector-cable Assembly
Gray Fitting