Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 25 / 104

Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019 25
Operate the Terminal Chapter 3
Install the Connection Cable to the MobileView 2711T Terminal
The connection cable can be attached on the right or left side of the MobileView
2711T terminal for right- or left-hand operation.
Use the following tools to install the connection cable.
• 19 mm open-end wrench or spanner
• Torx T10 screwdriver
• 8 mm hex key
To install the cable, perform the following steps.
1.
Decide on which cable-connection port of the terminal to install the cable;
see
Figure 2 .
Figure 2 - Cable Connections on MobileView 2711T Terminals
2.
If you want left-hand operation, remove the plug with an 8 mm hex key.
Set the plug aside.
3.
Remove the back cover as detailed on page 23 .
IMPORTANT The MobileView 2711T terminal is shipped with the cable connection port
open for right-hand operation. For more information, see
Figure 2 .
Back Cover
Cable connection
with open port
(as factory shipped). Cable connection
with hex plug
installed.
IMPORTANT The MobileView 2711T terminal is shipped with the above cable-connection
port open for right-hand operation.
When the cable is connected to this port, you can hold the terminal with your
left arm, operate the enabling switch with your left hand, and operate the
terminal touch screen with your right hand.