16
Apply a small amount of SRAM Butter to the poppet valve o-rings.
N OT I C E
Do not apply grease to the area between the poppet valve o-rings
as the post will not function properly if there is grease in that area.
17
Insert the poppet valve into the inner shaft, then use needle nose
pliers to press it firmly into the seal head.
18
Hold the seal head in place with an 11 mm open end wrench.
Thread the poppet valve cover onto the seal head, then use a
10 mm crowfoot socket to tighten the poppet valve cover to
5.7-7.9 N•m (50-70 in-lb).
Install the crowfoot socket at 90 degrees
to the torque wrench.
N OT I C E
To prevent damage to the poppet valve cover bleed screw, do not
allow the 10 mm crowfoot socket to contact the bleed screw of the
poppet valve cover.
10 mm
11 mm
5.7-7.9 N•m (50-70 in-lb)
No grease
25
REVERB STEALTH REASSEMBLY
