12
Install a new foam washer into the lower post.
13
Clamp the inner shaft in a vise with soft jaws. Thread the seal head
onto the inner shaft, then use an 11 mm crowfoot socket to tighten
the seal head to 5.7-7.9 N•m (50-70 in-lb).
Install the crowfoot
socket at 90 degrees to the torque wrench.
14
A specific amount of Reverb fluid must be removed from the inner
shaft. Consult the chart below and set the fluid level height for
your Reverb Stealth.
15
Insert the fluid level gauge into the inner shaft, then pull out on the
plunger to remove the fluid. Repeat this process until no more fluid
is removed from the inner shaft.
11 mm 5.7-7.9 N•m (50-70 in-lb)
Reverb Model
Length (mm)/ Travel (mm)
Set fluid level gauge to this
length (± 0.5 mm):
355 / 100
186.5
380 / 125
186.5
420 / 100
251.5
420 / 125
226.5
430 / 150
211.5
24
REVERB STEALTH REASSEMBLY
