Roche URISYS 2400, Operator'S Manual, Page: 47 / 166

Roche Diagnostics
Operator’s Manual · Version 1.0 B-23
URISYS 2400 3 Software
Installation
a
To change the reflectance values
1
Press <Set Reflect>. on the [Range Table] screen. The [Password] window
appears.
2
Enter the 4-digit password.
3 Press <Enter>. When the correct password is entered, the [Set Reflectance]
screen is displayed.
4 Press <Test> to select a test parameter.
5
Enter the new reflectance values between the indicated values. Apply
moderate changes and validate the effect to the evaluation sensitivity.
6
Press <Enter> after each value is entered.
7 Repeat steps 4-6 if reflectance values of other test parameters need to be
changed.
8 Press <PgUp> to return to the [Range Table] screen.
a
To set default concentration ranges and reflectance values
1 Press <Default> on the [Range Table] screen. The [Password] window
appears.
2 Enter the 4-digit password.
3
Press <Enter>. When the correct password is entered, the [Default]
window appears to confirm the change to the default settings.
4
Press <OK> to confirm. The changed concentration ranges and reflectance
values are set to default.
5
Press <PgUp> to return to the [Test Parameters] screen.
o
The screen allows for eight values to be set for each parameter. However, not all
of the values are used by the default settings.
o
Reflectance values that have been changed will be marked with a “#” flag on
the [Range table] screen as well as in the Parameter Settings printout. This flag
will also appear with the corresponding test parameter on the result printout.