RoboVent FloorSaver Series, Owner'S Manual

Page: 20 / 60

19 ROBOVENT • DFS SERIES OWNER’S MANUAL
Before operating your DFS Dust Collector, double
check the following items:
1. Be sure all electrical connections are secure and
wired properly.
2. Double check blower rotation. (see Figure 13).
3. Check the compressed air connection.
4. Before starting the unit make sure the motor
plenum door is locked shut.
Starting the DFS Collector
The DFS system comes complete with full electrical
controls and automatic pulsing system. The entire
contents of the control systems are installed inside the
electrical enclosure.
The Electrical Control Panel inside the equipment
cabinet contains the Service Disconnect, Motor
Starters and Controller. With the Service Disconnect in
the “ON” position press the “SYSTEM START” button
on the touch screen (this may either be remote, or
mounted on the unit) to energize the control system,
then continue through the “MAN FAN” and “LIGHTS”
and/or “START MODE” screens (if these option are
applicable) to the “BLOWER CONTROL” to engage the
Motor Starters and start the system blowers.
Auto On/Off Option
If your system is equipped with the Auto-Start Feature,
a “START MODE SELECTOR” screen will appear during
the above process (see Figure 15). Touch the selector
switch image to toggle between HAND and AUTO. In
the “AUTO” mode, the blower is cycled automatically
when triggered by welder operation and automatically
turns the unit off after approximately 3 minutes of
inactivity. The “HAND” position overrides this function
and the blower operates continuously.
SECTION 700
Operation
FIGURE 15