Robot Coupe Blixer 23 a, Manual

Page: 15 / 75

36
3° CLIPPING ON THE BELL
4
- Take the bell in the hollow of your hand and press the pusher
7
in
with your thumb.
- Slot it onto the section of tube
1
protruding from the underside of
the lid.
- Release the pusher
7
.
- The pusher should return to its initial position. If it does not, gently
press on the bell and it will automatically click into place.
- Check that the bell is securely attached to the tube
1
.
4° USING THE VACUUM KIT R-VAC ®
- Connect up the vacuum pump to valve A , check that the latter is open
(lever in shaft of connector).
- Shut valve B (perpendicular lever).
1° ASSEMBLING THE VACUUM KIT R-VAC ®
- Insert filter
2
into body
3
- Screw the tube
1
onto the body
3
(the tube should pass through the body
3
).
2° POSITIONING THE R-VAC ® VACUUM KIT ON THE LID
- Sit the R-VAC ® kit on top of the plastic cone
5
, which should be
screwed onto the lid rest
6
, with the lid holder
8
in between. The
lid (opaque white)
9
slots onto the lid rest
6
.
5° ADDING LIQUID TO THE MIXTURE
- Attach a tube to valve B .
- Immerse the other end of this tube in the liquid to be added.
- Open valve
B slowly ; once the liquid has been added, shut valve B .
OPERATING INSTRUCTIONS FOR THE VACUUM KIT R-VAC
®
- VERTICAL CUTTER-MIXER ONLY
Keep an eye on
the position of the
O-ring seal when
fitting part
1 .
Filter
2
can
be cleaned .
N O T E
Preheat the vacuum pump (approx. 15 minutes) to check that both
it and the vacuum kit are working properly. Similarly, leave the
pump running for 15 minutes after completing the task in order to
evacuate the condensation.
9
5
8
6
4
7
Check that the
openings are in
the upper position
in order to position
nut
4 .
B
1
2
3
4
A
VCM - BLIXER An:VCM - BLIXER 10/01/13 10:07 Page 36