Robot Coupe Blixer 23 a, Manual

Page: 9 / 75

30
SWITCHING ON
THE MACHINE
• ADVICE ON ELECTRICAL CONNECTIONS
The wiring must be installed by a qualified
electrician.
Before plugging your appliance in, check that your
power supply voltage is the same as that indicated
on the motor identification plate.
If your appliance is not connected to the mains
via a plug and socket, it must be connected via an
insulating selector switch that can be padlocked.
Switch on your appliance while empty to check
that the blade rotates in an anticlockwise direction.
If the blade turns in a clockwise direction, invert the
positions of two wires, as follows :
DO NOT DISCONNECT THE GREEN AND YELLOW
eartming wire
Invert the positions of one of the following pairs of
wires :either
and
or and
or and
ROBOT-COUPE appliances are fitted with the follo-
wing types of motor :
400 V / 50 Hz / 3
220 V / 60 Hz / 3
230 V-400 V / 50 Hz / 3
4) Clip the lid onto the
lid rest and turn it so that
the bosses are inside the
arm.
The logo should now be
facing you, lined up with
the handle, with the
safety magnet on the
right.
5) To close the lid, fit the
locking catch over the
edge of the bowl and
push the handle down.
DANGER : RISK OF INJURY
The blades are extremely sharp.
For this reason, always make sure you have
removed the blade assembly before doing
any job inside the bowl, such as cleaning or
emptying.
RISK OF ELECTROCUTION
• The machine must be earthed.
• The appliance is only insulated from the
mains supply when it is unplugged.
• LID-WIPER ASSEMBLY –
VERTICAL CUTTER-MIXER ONLY
Hold the lid wiper in one hand and the handle in
the other. Press the two parts together at the centre
of the lid, then turn the handle 45° in an anticlock-
wise direction.
• SCRAPER ARM ASSEMBLY -
BLIXER
®
ONLY
Hold the scraper arm in one hand and the handle
in the other. Press the two parts together in the
centre of the lid, then rotate the handle 45° in an
anticlockwise direction.
VCM - BLIXER An:VCM - BLIXER 10/01/13 10:05 Page 30