Robot Coupe Blixer 23 a, Manual

Page: 23 / 75

44
standards
Consult the declaration of compliance on page 3.
Blixer
®
60
R 60
11000 W
400 V/50 Hz/3
1500
3000
16.1
26.0
50
220 V/60 Hz/3
1800
3600
32.5
45.0
63
380 V/60 Hz/3
1500
3000
16.1
23.8
50
230 V/50 Hz/3
1500
3000
27.7
44.8
63
* See note.
- Power shown on data plate.
Model Motor
Speed
(rpm)
Nominal
current
(Amp)
Motor switch-on circuit *
b recommended
differential - (Amp)
saFEtY
These appliances are fitted with an
electromechanical
safety device and a motor braking system (blades
halted in under 2 seconds by the electric motor
brake).
Moreover, the machine will only start if the bowl is
correctly positioned on the motor unit.
However, we recommend that you stop the motor
before opening the lid, especially when liquid
preparations are involved, in order to avoid
splashing (before opening the lid, wait a few
seconds).
These models are also fitted with a
thermal pro-
tection system,
with automatic reset, which stops
the motor if it is left on for too long or overloaded.
These models are also fitted with a thermal alarm
(the red light comes on) warning the user that the
appliance is about to stop.
If this happens, wait until the appliance has cooled
down before switching it back on (the orange light
will go out and the green lights will come on again).
w a r n i n g
the blades are extremely sharp.
Handle with care.
r E m E m b E r
never try to override the locking and safety
systems.
never insert an object into the container where
the food is being processed.
never push the ingredients down with your hand.
do not overload the appliance.
never switch the appliance on when it is empty.
when the appliance is switched on, the cur-
rent is several times greater than the nominal
current.
“the switch-on current of appliances must be
taken into account when determining the
cross-section of the conductors and choosing
the systems that protect against excess cur-
rent, in order to avoid excessive voltage drops
during the switch-on period and the untimely
triggering of the protective device.”
we advise you to use a protective device
specific to the switching-on of asynchronous
motors. see recommended size in the table
above. in every case, you must comply with
the legislation currently in force.
*
n o t E