GoBoard B2 User Manual
www.roboconn.org
Contains confidential and proprietary information which may not be copied, disclosed or
used by others except as expressly authorized in writing by ROBOCONN.
14
5.3.1
Skateboard Heading
If the skateboard speed is less than 2 Km/h and the shift switch is pressed less than 1 second, the skateboard toggles its
heading.
5.3.2
Cruise Mode
If the skateboard speed is more than 2 Km/h and the shift switch is pressed less than 1 second, the skateboard enters the
cruise mode. Pushing the throttle knob in backward direction exits the cruise mode.
5.3.3
Head Light Co
n
trol
Long pressing shift switch more than 4 seconds toggles the headlight.
5.4
Power Switch
If the power switch is pressed for more than 1 second, the remote is powered on. Doing so while the remote is powered
on shuts down the remote. If the remote is connected to skateboard and skateboard is powered off in normal conditions
(there is not any error state), the remote is also powered off automatically.
5.4.1
Speed Levels
There are 4 speed levels in remote control mode i.e. 10 Km/h, 20 Km/h, 30 Km/h and 40 Km/h stated as first, second,
third and fourth speed level respectively. Short pressing (less than 0.5 seconds, each time) the power switch x times one
after other selects the x speed level while the throttle stick is at mean position of higher (while accelerating). Where x
can be 1, 2, 3 and 4. The total time duration should not take more than a second. After a second, the number of beeps
ensures the selected speed level has been accepted successfully. The first 3 speed levels are normal speed levels, while
the 4 speed level is sports speed level. Only advanced riders are allowed to use this. When the skateboard is powered on
and remote is connected, the default speed level is level 1.
5.4.2
Brake Levels
There are 4 brake levels in remote control mode i.e. 25%, 50%, 75% and 100% stated as first, second, third and fourth
brake level respectively. Short pressing (less than 0.5 seconds, each time) the power switch x times one after other
selects the x brake level while the throttle stick is pushed backwards (while braking). Where x can be 1, 2, 3 and 4. The
total time duration should not take more than a second. After a second, the number of beeps ensures the selected brake
level has been accepted successfully. When the skateboard is powered on and remote is connected, the default brake
level is level 1.
5.5
Skateboard Battery LEDs
Skateboard battery LEDs represents the battery level of the skateboard battery once the skateboard is connected to
remote. There 4 LED representing 100%, 75%, 50% and 25%.
5.6
Connection LED
Connection LED shows the signal connection status. If the connection LED is constantly on, it means the remote is not
connected to skateboard. If the connection LED is blinking slowly i.e. approximately 2 times a second, it means the
remote is connected to skateboard and signal strength is good. If the connection LED is blinking fast i.e. approximately
5-6 times a second, it means the remote is connected to skateboard but the signal strength is poor. In remote pairing
mode, the connection LED blinks 1 times a second.
