GoBoard B2 User Manual
www.roboconn.org
Contains confidential and proprietary information which may not be copied, disclosed or
used by others except as expressly authorized in writing by ROBOCONN.
12
4.6
Power Button
Power button is used to power on and power off the skateboard. Short pressing the button powers on the skateboard
and long pressing for 1.5 seconds powers off the skateboard. Powering off the skateboard only works when the
skateboard’s speed is zero. If the skateboard is powered on and it’s not being used for 10 minutes, the skateboard starts
to beep and automatically shuts down.
4.6.1
Head Light
Short pressing (less than 0.5 seconds, each time) the power switch 2 times one after other toggles the head light
followed by a beep.
4.6.2
Balance Control Mode
Short pressing (less than 0.5 seconds, each time) the power switch 3 times one after other toggles the balance control
mode from beginner mode (followed by two beeps) to advanced mode ( followed by one beep). Once you select the
control mode, that control mode is saved and selected forever unless you change it. Make sure your remote is
disconnected during this process.
4.6.3
Disable Auto Weight Sensor Calibration
Short pressing (less than 0.5 seconds, each time) the power switch 4 times one after other disables the auto weight
sensor calibration function. This process accompanies an alarm which lasts for 5 seconds and it is terminated by a beep.
Make sure during this process, your skateboard is placed perfectly flat on the ground and there should not be any weight
on the skateboard. Also the remote control should be powered off. This function cannot be enabled again unless you
restart your skateboard.
4.6.4
Motor Self-Run Test
Short pressing (less than 0.5 seconds, each time) the power switch 5 times one after executes motor self-run test. The
process starts with 4 beeps and ends with 4 beeps with an automatic shutdown. Make sure the motors of skateboard
should be unloaded and free to move otherwise this can disturb the normal function of the skateboard.
Note: The end user is not recommended to use this function.
4.6.5
Radio Pairing Mode
If we power on the skateboard by pressing the power on switch and keep holding it pressed for 6 seconds till a beep is
heard while the remote is not connected, the radio chip enters in the paring mode. The buzzer continuously beeps in this
mode.
4.6.6
Remote Throttle Stick Calibration
If we power on the skateboard by pressing the power on switch and keep holding it pressed for 6 seconds till a beep is
heard while the remote is connected, the remote throttle stick’s mean position is calibrated. The stick position should be
at mean position during this. A short beep indicates the process has finished.
4.6.7
Hard Shut Down
Long pressing the power button for 6 seconds after releasing the switch during power on will shut down the skateboard
in any case i.e. even motors speed is not zero.