Robe ROBIN iPointe65, User Manual

Page: 8 / 66

8
Inserting and locking the lamp
Lamp in unlocked position Turn the lamp right Lamp in locked position
3.3 Aligning the lamp
The lamp holder is aligned at the factory. Due to differences between lamps, a fine adjustment of the lamp
holder may improve light performance of the fixture.
The three screws (A,B, C) serve for fine aligning of the lamp´s hot spot in a light image.
Warning
Wear proper eye and skin protection prior to remove the lamp cover.
High voltage present at lamp fastons.
To adjust the lamp in the fixture.
1. Connect the fixture to mains, switch on the lamp, open shutter and dimmer, set zoom on suitable size, aim
and focus the image on the wall (both static gobo wheel a rotating gobo wheel have to be set at 0 DMX).
2. Loosen the four hex socket head screws (1) ( use an Alen key 2.5) on a lamp cover and remove
the lamp cover (2).
3. Ajust the lamp holder into desired position by using the three screws A,B,C (by means of an Allen key 4).
4. Carefully check the gasket (5) for signs of deformities or hardening and if it is correctly placed in the groove of
the head housing.
5. Re-insert the lamp cover (2) and tighten the four hex socket head screws (1) using a tightening torque
of 2-2.3Nm. The screws(1) must be tighten in the order 1-->2-->3-->4.