Robe ROBIN iPointe65, User Manual

Page: 33 / 66

33
9. Error and information messages
Error in the fixture is signalled by the yellow warning icon at the bottom line of the screen:
Press the [ESCAPE] button to display error messages.
List of error and information messages:
Lamp Error
If the ignition of the lamp is 3 times unsuccessful , the display shows “Lamp Error”, meaning that the lamp could
be damaged or even missed or there could be a failure on the lamp driver.
Overheated
This message informs that the fixture had been overheated and the lamp was switched off by means of the
head temperature sensor.
Temper. Sensor Error
The message informs you that the communication between the head temperature sensor and the main pro -
cessor failed and the lamp has been switched off.
Active Lamp Timer
This message appears if you try to switch on the hot lamp. The fixture tries to ignite the lamp and during time
period before next attempt of the lamp ignation the message is displayed. Also faulty (missing) lamp can be
reason of the message.
Faulty battery
The battery on the display board is exhausted and should be replaced immediately.
Tilt Error 1
(Tilt Error 2)
This message will appear after the reset of the fixture if the head´s magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head
is not located in the default position after the reset.
Pan Error 1 (Pan Error 2)
This message will appear after the reset of the fixture if the yoke´s magnetic-indexing circuit malfunctions (sen -
sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The yoke is not
located in the default position after the reset of the fixture.
Colour Wheel Error 1(Colour Wheel Error 2
)
The messages will appear after the reset of the colour wheel if this wheel is not located in the default position.
Cyan 1(Cyan Error 2
)
The messages will appear after the reset of the cyan colour wheel if this wheel is not located in the default position.
Magenta 1(Magenta Error 2 )
The messages will appear after the reset of the magenta colour wheel if this wheel is not located in the default
position.
Yellow 1(Yellow Error 2
)
The messages will appear after the reset of the cyan colour wheel if this wheel is not located in the default position.
Strobe Error 1 (Strobe Error 2 )
The messages will appear after the reset of the dimmer/strobe module if the strobe lamellas are not located in
the default position.
Pattern 1 Error 1 (Pattern I Error 2 )
The messages will appear after the reset of the prism wheel 1 if this wheel is not located in the default position.